It is generally a hexahedron made of copper or steel(2020年06月16日)

fullwaystripcoppera — 2020-06-16T12:21:03+0900

It is suitable for large units or control rooms. ③ Shield clothing, shield helmet and shield eye mask. Magnetic isolation can use the following methods: ① shielding cover. A copper wire mesh or microwave absorbing material is sandwiched between the shielding suit and the shielding helmet. Used for personal protection, mainly to protect microwave workers. Use special magnetically conductive materials for magnetic isolation.

Precise electromagnetic measurement under low temperature conditions, using superconducting materials can play a complete electromagnetic shielding role. For low-frequency electromagnetic interference, it is often made of ferromagnetic materials such as iron or beryllium-molybdenum alloy to improve the shielding effect. ②Shielded room. The shielding goggles usually have a three-layer structure with pure copper strip a copper wire mesh in the middle. When the shielding requirements are low, one or two layers of fine metal mesh can be used instead of metal plates. It is generally a hexahedron made of copper or steel plate.Can't. It is suitable for small instruments or devices, generally a dense shell made of copper or aluminum.

(3) has some special mechanical properties such as excellent friction reduction and wear resistance (such as bronze and some brass), high elastic limit and fatigue limit (such as beryllium bronze, etc. There are two types of pure copper products: smelted products and processed products..; it has good thermal conductivity and is commonly used to manufacture magnetic instruments and meters that require anti-magnetic interference, such as compasses, aviation instruments, etc. See Table 1 and Table 2, respectively. (Purple copper) Pure copper is a rose-red metal, and the surface is purple after forming a copper oxide film, so industrial pure copper is often called red copper or electrolytic copper. (4) Beautiful color 2
https://www.fullwaytech.com/

The power supply must be closed before changing the fixture(2020年05月14日)

fullwaystripcoppera — 2020-05-14T15:09:28+0900

Copper belt machine must pay attention to the details when operating

Before the copper belt machine is powered on, please confirm that the power supply (fuse 3A250V) voltage is AC220V or AC110V; if your power socket is not grounded, please connect the mechanical shell to the ground with thick wires;
It is strictly forbidden to place any objects on the copper belt machine or the controller, so as not to fall into the chassis to form a mechanical task or change the circuit short circuit destruction machinery and other serious problems;

Do not block the heat dissipation holes of the chassis;

Copper belt captain should close the power supply when not working;

The power supply must be closed before changing the fixture or moving the transfer machine;

When starting the motor, please confirm whether the clamp can be locked to prevent flying out and hurt people.
https://www.fullwaytech.com/

Fullway copper tapes

It is generally a hexahedron made of copper or steel(2020年06月16日)

The power supply must be closed before changing the fixture(2020年05月14日)