What are the Correct Operating Procedures for Cold Roll Forming Machines?

(2022年01月12日)

https://www.hzrollforming.com/products/roll-forming-machine/

Founded in 2003 and located on the east coast of China, Zhejiang economic, cultural and political center - Hangzhou, Hangzhou Roll Forming Technology Co., Ltd. is committed to the research and development of suitable machinery for building steel structure, represented by roof plate, wall panel cold bending machine, and also manufacturing steel structure pretreatment equipment, roll forming machine, C/Z/U/M light steel, H beam welding line, welding pipeline, all kinds of cold bending machine, slitting line, cut to length line etc.

When the cold roll forming is finished, the cold roll forming machine will close the mechanical transmission system and at the same time activate the hydraulic system to retract the hydraulic cylinder. This operation of the china cold roll forming machine ensures the strength of the material, improves the quality of the supporting steel arch, greatly improves the work efficiency, and makes the operation simple and clear.

The safe operating procedures of the cold roll forming machine are as follows:
1. Strictly abide by the safety operation regulations of machine operators, and wear labor protection equipment as required.

2. The upper and lower molds should be cleaned before starting the machine.

3. Check whether there are any foreign objects on the material support, stopper, and slider. If there are foreign objects, they should be cleaned up.

4. Choose an appropriate die according to the thickness of the folded sheet. The size of the die is generally equal to or greater than 8 times the thickness of the sheet.

5. The roll forming force of the workpiece is obtained from its sheet data or the calculation formula of the roll forming force, and it should not be greater than 1000KN.

6. When roll forming narrow sheets, the working pressure of the system should be appropriately reduced to avoid damage to the mold.

7. When adjusting the slider stroke, ensure that the adjustment volume is less than 100 to avoid damage to the machine.

8. Before roll forming, the gap between the upper and lower molds should be adjusted uniformly.

9. When roll forming, don't put your hands in the mold room, and don't hold long and narrow materials with your hands. Only one piece of material is allowed to be roll formed at a time.

10. The roll forming sheet should be placed in the middle of the mold, and the machine should not be loaded on one side, so as not to affect the accuracy of the workpiece and the cold-formed steel machine. If some workpieces do need to work on one side, the load should not exceed 250KN, and both sides must be roll-formed at the same time.

11. Check the oil level of the oil tank, start the oil pump and check the hydraulic pipeline and oil pump for abnormalities.

12. Immediately stop the machine when an abnormality occurs, check the cause and eliminate it in time.

roofing-tile-glazed-tile-making-machine.jpg

コメント