年表作成・共有サービス - pastport

https://www.dmncedm.com/how-to-cut-aluminum-by-wire-cutting.html

Wire EDM aluminum has always been a big problem. The conductive block wears quickly, the molybdenum wire is easily broken, and the working time of the working fluid is short. These are very common problems. In today's article, as one of the professional CNC EDM machine suppliers, DMNC will systematically analyze how to cut aluminum by wire-cutting EDM properly.

1. Reasonable combination of pulse electrical parameters
When machining edm aluminum parts by CNC wire cutting EDM, the wider pulse width is likely to produce larger alumina or particles with alumina on the surface. If the pulse interval is too small, it will also produce larger particles. The molybdenum wire easily adheres to these larger processed particles, which affects the conductivity and has a great negative impact on electrical discharging. Increasing the no-load voltage amplitude of the pulse power supply, reducing the pulse width and processing pulse gap can reduce the possibility of processing debris attached to the electrode wire(molybdenum wire).

2. Requirements for working fluid of moly wire EDM
In order to keep the moly wire EDM cutting fluid clean, make it work normally and effectively, and extend the service life of the working fluid, thick sponges can be used to prevent debris from flowing into the water tank, keep the waterway open, and reduce the adhesion of processing debris on the molybdenum wire. Clean or replace the sponge pad regularly. The amount of water sprayed from the upper and lower sides of the moly wire edm aluminium fluid should be uniform and try to use a water tank with a good filtering effect to remove the erosion in time.

3. Use a special brass wire
Now, there is special brass wire on the aluminium wire cutting machine to cut aluminum parts, the diameter is 0.20mm

4. Install special aluminum cutting device
If the wire-cutting machine is used to process large quantities of EDM aluminum parts in the CNC EDM machine for sale, the processing problems will be more prominent, and the above-mentioned measures will not be able to fundamentally solve the problem. This needs to be considered from the perspective of machine transformation, and electrical conductivity is no longer used. The block power supply method, such as the wire barrel power supply method, can be suitable for production and processing. It is equipped with a special device for cutting EDM aluminum parts (carbon brush), which can supply electricity to the wire barrel and guide wheel, which can slightly increase the service life of the power feed contact.

For more information about electrical discharge machining products, please feel free to contact us!