年表作成・共有サービス - pastport

https://www.lesunscrew.com/from-which-aspects-is-the-output-of-extruder-screw-compared.html

Output is a main indicator to measure the performance of the extruder screw. However, it is of little significance to only emphasize the percentage increase in the output of the improved screw over the original screw, because the benchmark for comparison is not clear.

From the theory of fluid dynamics, we know that if a screw with a smaller screw edge clearance is used to replace the worn screw, the output will also be greatly improved. In order to accurately reflect the performance of the extruder feed screw in this aspect, it generally can be compared from the following four aspects.

1. The specific flow rate of the Lesun extruder screw (Q/n)

That is to compare the output of different extruder screws per unit speed on the premise of qualified quality. Since the actual output Q (kg, Hr) and speed n (rpm) can be measured, the specific flow rate Q/n is easy to calculate, and its unit is (kg/Hr)/rpm, that is, hourly output of each extruder screw.

If the Q/n value is too small, then other comparisons are meaningless, because it means that the extruder screw design calculation is unreasonable, or the process operating conditions are unreasonable.

2. The conveying efficiency of the extruder screw η

The ratio of actual output Q to theoretical output Q1. η=Q/Q1 The actual output can be measured, but there are many calculation methods and formulas for the theoretical output Q1. When the extruder screw parameters and density are known, the denominator is constant, so the specific flow rate Q/n is related to the conveying efficiency η, and it is obviously proportional.

That is, the greater the specific flow rate, the higher the delivery efficiency. Therefore, we can simply compare the transmission efficiency by measuring the specific flow rate. For the extruder screw design, the concept of conveying efficiency is a very important concept, which reflects the comprehensive performance of the screw extrusion system.

3. The highest output Qmax of the extruder screw

The main goal pursued by the extruder screw designer is to obtain the highest possible output under the premise of ensuring quality. When comparing the maximum output Qmax of two screws, a formula can be used to calculate the maximum output of each screw.

4. the "hardness" of the extruder screw characteristics

The so-called "hardness" of the extruder screw characteristics refers to the decrease in output when the head pressure increases.