ASTM B861 Grade 9 Titanium Tube
(2022年05月12日)Grade 9 titanium tube:
Grade 9(3Al-2.5V) titanium is an alloy consisting of 3% aluminum, 2.5% vanadium, and 94.5% pure titanium. This titanium alloy can be used in higher temperatures than commercially pure titanium grades 1-4, as it can be cold rolled with its excellent corrosion resistance capability its used in industrial, aerospace and sporting equipments.Final application in :
Titanium Bicycle
Titanium Wheel-chair
Titanium Golf
The Shell of Sensor in Ocean
Aerospace Applications
Our Gr.9 titanium tube are widedly used for bicyle frame,which can be bent at room temperature using standard bend techniques. It is routinely bent on a radius of three times the actual tube diameter. Moreover, thin walled tubing requires adequate support of the ID during bending. Because of the high strength and low modulus of this alloy, springbuck is about twice that of stainless steel.
The Grade 9(3Al-2.5V) Titanium Tube For Bicyle Frame alloy is characterized by-
1. Excellent resistance to seawater corrosion
2.Highest mechanical strength
3. Excellent strength to weight ratio
4.Resistant to stress corrosion cracking in chloride and sour gas environments
5. Excellent resistance to pitting, crevice and erosion corrosion
6. Good formability and weldability
7. Very low thermal expansion
Chemical Composition
Al
V
N
H
O
Fe
C
≤3.5 - 2.5
≤3.0 - 2.0
≤0.02
≤0.013
≤0.12
0.25
0.1
Mechanical Properties
Ultimate Strength
Yield Strength
Elongation 2"
ksi
Mpa
ksi
Mpa
%
Annealed
90
621
70
485
15
CWSR
125
862
105
724
10
Titanium Tube Grades Comparison Table
Grade
UNS
ASTM/ASME
W.Nr
AFNOR
3Al2.5V Titanium
R56320
Grade9
W.Nr. 3.7195
T-A3V2.5
Standard: ASTM B338, ASTM B86
1Outer diameter Range: 6mm ~ 250mm
Thickness Range: 0.5mm ~ 20mm
Length: Not exceed 15 Meters
Condition: Full Annealled
Tolerance Control: OD ±0.1mm, Avg Thickness: ±10% Min Thickness: +10%/-0
Extra Service: Cutting, Machining, Polishing, Bending
Quality Control:
We use the Class A raw material to guarantee our titanium tubes quality. Shaving and boring to control the surface. NDT test (Hydrostatic, Pneumatic, E.T. U.T) to make sure each tube without crack and defect.
As a leading 3Al2.5V seamless titanium tube manufacturer, Unidus Titanium adheres to strict quality
standards to produce titanium tube. We guarantee our tube meet our customer's
special requirement.Below normal testing for titanium seamless tube:
Chemical
Compostion
Ultrasonic
Test
Elongation
Visual
Inspection
Eddy current
test
Flattening
Pneumatic test
Hydrostatic
test
Flaring
Dimensional
Inspection
Tensile and
Yield
Hardness
https://www.unidusmetal.com/titanium-and-titanium-alloy-materials/
- «前のできごと |
- 次のできごと»
- このできごとのURL:
コメント