The information described before for the second blow

(2020年04月25日)

Stay in the two-step blow molding machine material in the blow molding machine type WLK combined with uniaxial blow molding into particles in the range of 40 mm, follow up time, and then use New Zealand blow molding machine to be blown 3 ~ 10 mm of grain, which is especially The information described before for the second blow of blow molding. In order to prevent blow molding machine problems, it is necessary to continue to maintain proper maintenance, these requirements are usually difficult to guarantee by manual operation.

Once the feed is too , it usually leads to uneven blow molding, and high noise attack, the result is that the material accumulates or damages the material to weaken its heat due to conflict. In addition, the high sensitivity of the information is cumbersome, and a high frequency of frequent blade replacement blade wear remains to be seen. Compared with the two-step blow molding machine that can be charged, the hopper has a buffering effect.

Feeding a complete set of optimized production processes in this way means seriously, because operators don't want to continuously operate the blow molding machine, and then switch between operations after they are busy with other work. Very good in the secondary type blow molding machine. The two blow molding machines can be selected as one higher than the other, or one after the other. The cutting machine of the secondary blow molding machine operates on the basis of the working principle, and the specially designed particles are in the blow molding process.

Compared with the general type blow molding machine, the second generation blow molding machine has a smaller volume and completes the transmission system with less energy. Because of its unified feeding, it works at a speed of about 450 minutes and has never been attacked by faults. When such a blow molding machine is used in the process of second damage to blow molding materials, the one-step processing of noise level and speed attacks is also much lower.
https://www.tzhengmei.com/product/mold/

  • «前のできごと |
  • 次のできごと»

コメント