Common Alarm and Maintenance of Lubrication System in Machining Center
(2021年06月03日)Looking for the best deal of machine tools? You are here in the right place. Sealion is one of the CNC machine tools supplier who can always help you. Sealion may not only offer you a wide selection of quality machine tools in the global market but also help you to maintain CNC machine tools and horizontal boring milling machine with the best offer and support as well.
The alarm of insufficient pressure in the lubrication system of CNC turning lathe center
1. When you manually check whether the pressure meets the requirements. Generally, the insufficient pressure is caused by the oil pipe leaks or the filter screen of the oil pump is too dirty. If there is an external filter, check it, insufficient pressure will occur if the oil is mixed, or sometimes the temperature is too low.
2. It may be that your parameter settings of cnc turning lathe are not appropriate, the interval between oiling is too long, and when the oil pressure is not up, it will detect the oil pressure and cause an alarm. Solution: set the oiling time longer and extend the oil pressure detection time (500ms shorter than oil pumping).
CNC turning lathe center lubrication system maintenance
1. Check the condition of the lubrication system and pressure gauge, clean the filter screen of the lubrication system, replace lubricating oil and dredge oil circuits.
2. Check the gas system, clean the air filter screen, and eliminate the leakage of pressure gas.
3. Check the fluid system, clean the filter, clean the oil tank, replace or filter the oil. If possible, replace the seal.
4. Fasten the transmission parts and replace the defective standard parts.
5. Grease lubrication parts, according to the requirements, add grease
6.Clean the transmission surfaces.
We also provide boring mill machine, cnc equipment, twin spindle lathe, engine machining tools, vertical turret lathe for sale, vertical milling machine for sale and so on.
- このできごとのURL:
コメント