年表作成・共有サービス - pastport

https://www.zetian-group.com/products/ms-1000-dust-monitor/
https://www.zetian-group.com/products/continuous-emission-monitoring-process-control/

HANGZHOU ZETIAN TECHNOLOGY CO., LTD was established in 2008 and has a national wide impact in China now as a rapid development company in environmental protection and industrial process control. We focus on Ultra-violet DOAS gas analyzer, Laser TDLAS gas analyzer, air quality monitor, water quality testing
, continuous emission monitoring system and etc, basically covering air pollution monitoring, metallurgical industries, chemical, refinery industries, cement, sulfur recovery, flue gas and other online monitoring needs.

The methods of dust particle measuring device mainly include optical analysis method and non-optical analysis method. Non-optical analysis method is difficult to monitor the dust concentration in real time because of its slow response speed and complex processing.

For example, the existing chemical reaction dust concentration sensor needs to collect and process air dust, which has measurement delay difference and cannot be measured in real time. However, the safety of the electric dust concentration measuring device is poor. When the dust concentration in the mine is too high, a slight electric spark will cause the risk of mine explosion.

The technology of this type of CEMS analyzer based on optical analysis has the characteristics of high detection sensitivity, strong selectivity and fast response, which is suitable for on-site real-time monitoring and low cost. It is an ideal method for dust concentration measurement in the future.

However, the existing handheld dust concentration measuring devices must require operators to measure in the field, and in the environment similar to coal mines with high dust concentration, operators must take dust-proof measures during the measurement, otherwise the respiratory tract will be damaged and health will be affected.

In addition, since the measuring instrument is located in the area of high dust, dust deposition must occur on the surface or inside the instrument after long-time use, which will affect the measurement accuracy.